Album: December 2002 Duane Hill gave an excellent demonstration on turning captive rings.
At the Denis Falch studio in Winona, MN. Last change: 09/08/10
Contains: 19 items. Viewed: 1283 times.
|
Album: November 2002 A demo by Ken Grunke on turning inside-out ornaments, held at the Bill Gautsch studio in Onalaska, WI.
More ornaments by Ken can be seen hereLast change: 09/08/10
Contains: 19 items. Viewed: 1379 times.
|
Album: October 2002 Dave Dapkus gave the group an excellent demo on turning miniature birdhouse ornaments. Held at Denis Falch's workshop space in Winona, MN. Last change: 09/08/10
Contains: 19 items. Viewed: 1390 times.
|
Album: September 2002 Aaron Gesicki showed the group eccentric turning using Owen Lowe's "wankel rotor" offset technique. This meeting was held at A-Line Tools new annex building in LaCrosse. Last change: 09/08/10
Contains: 13 items. Viewed: 1070 times.
|
Album: August 2002 Held at Shorty Mueller"s winter retreat near Alma, WI. After members gazed in awe at the beautiful log structures (the cabin, sauna, and shop/garage) they sat down to Duane Hill's demo on turning spheres. Last change: 09/08/10
Contains: 10 items. Viewed: 982 times.
|
Album: July 2002 The annual toolmaking session/picnic, held at the Jim Cox getaway near West Salem, WI Last change: 09/08/10
Contains: 14 items. Viewed: 987 times.
|
Album: June 2002 June meeting at the Bill Gautsch Studio. Ken Grunke demo'd Chatterwork and Duane Hill demo'd hollowing tools. Last change: 09/08/10
Contains: 10 items. Viewed: 990 times.
|
Album: April 2002 Brother Finbar McMullen, on sharpening tools. Held at Denis Falch's shop, in Winona. Last change: 09/08/10
Contains: 7 items. Viewed: 1046 times.
|
Album: March 2002 A thread chasing demonstration by Jeff Pohl, held at Bill Gautsch's shop Last change: 09/08/10
Contains: 6 items. Viewed: 1017 times.
|
Album: February 2002 Our finishing gurus, Jim Cox and Aaron Gesicki, give the group some valuable tips Last change: 09/08/10
Contains: 7 items. Viewed: 1047 times.
|
Album: January 2002 Charlie Cadenhead's demo on turning a lidded box.
Charlie has prepared a tutorial which you can view here.Last change: 09/08/10
Contains: 8 items. Viewed: 4979 times.
|
