Business announcements and introduction by Bill Gautsch
Viewed: 244 times.
|
Bill's pride and joy, with new headstock bearings and linkbelt.
Viewed: 243 times.
|
A beautifully carved bowl by Dave Dapkus
Viewed: 235 times.
|
Ken Grunke starting his demo--gluing up a blank.
Ken prepared a tutorial printout for the members, it can be downloaded here in PDF form (53 kb) Viewed: 275 times.
|
An enthralled crowd?
Viewed: 254 times.
|
Starting the second stage of turning an ornament.
Viewed: 290 times.
|
Roughing out
Viewed: 278 times.
|
Using the skew chisel to turn the body. The inside profile can easily be seen, to judge the shape of the outside.
Viewed: 264 times.
|
Ken is turning a second design, using his shopmade round skew chisel.
Viewed: 266 times.
|
Checking wall thickness.
Viewed: 273 times.
|
Uh, the finished piece (next one is much better)
Viewed: 255 times.
|
The completed turning, with a ring of peeled shavings at the bottom. This was unplanned, but Ken decided to go with it for the effect. Turned from white oak, about 3 1/2 inches long, and 1 1/4 inch diameter.
Viewed: 293 times.
|
A nice bowl by Denis Falch, of Winona.
Viewed: 249 times.
|
A hollow vessel by Denis Falch.
Viewed: 231 times.
|
Ansel Heram turned this beautiful mobile of segmented hot-air balloons.
Viewed: 276 times.
|
